|Thicker 16-gauge loop wire, most other use thinner 18 gauge.
|More copper means a better performing detector and increased tensile strength.
|LLDPE outer jacket material. Same material as used in XLP.
|Tough abrasion resistance jacket will assure top loop performance.
|Custom designed polyethylene wedge shaped jacket with wings. (built in backer-rod)
|Eliminates the need for a backer rod to hold loop to the bottom of saw-cut groove. No chance of air pockets and use 40% less sealant since bottom half of the groove is completely sealed.
|Easy to follow instructions with template for dog-ear corner cut.
|Takes confusion out of the installation process.
|Pre-phased at the factory.
|Saves time when installing two loops to one detector for a slide or vertical gate.
|Loop wire jacket and lead-in jacket are the same size.
|No need to make a second saw-cut for lead-in run.
|Ensure top performance.
|Pre tested at factory 3 ways.
|Tested with meg-ohm meter, inductance meter, and with an actual loop detector.
|Optional installation kits: TB-KIT and PR-3/16.
|Tools to make the job easier, eliminates making the wrong sized cut by using the loop itself as a template for chalking lines.
|Compact size and reduced weight.
|Saves on shipping cost and warehouse space.