GTO SW3200XLS Replacement Arm with 40' Cable for SW3200XLS Operators - Secondary Arm Only
The PROSW3200ARMXLS is a replacement secondary actuator arm for the Linear / GTO PRO-SW3200XLS dual swing gate operator family. In a dual swing system, the second arm needs the correct cable length and connector arrangement so it can reach the control box and operate in sequence with the master actuator. A replacement arm should be matched to the exact opener model rather than chosen by appearance alone.
This arm is commonly ordered when the secondary leaf stops moving, the actuator housing is damaged, the cable is cut, the internal drive has failed, or a gate strike has bent the arm. Before replacing the arm, a technician should also inspect hinge condition, gate swing balance, bracket geometry, battery voltage, control board outputs, and wire condition. A failed board or damaged cable can look like a failed actuator if the system is not tested carefully.
Find Replacement Parts for SW3200XLS
Compatible With
Primary Fitment
Not Interchangeable With Without Verification
Features & Specifications
| Manufacturer | Linear / GTO |
|---|
| Product Type | Replacement secondary swing gate actuator arm |
|---|
| Part Number | PROSW3200ARMXLS |
|---|
| Application | Secondary arm for SW3200XLS dual swing systems |
|---|
| Cable Length | 40 ft, based on uploaded product name and common listings |
|---|
| Compatible Operator Type | Residential swing gate operator |
|---|
| Gate Application | Select dual swing gate installations; verify by operator model and parts diagram |
|---|
Also Known As / Related Part Numbers
Technician Note
Do not use a secondary arm to replace a primary/master arm unless the parts diagram specifically confirms it. Cable length, control-box location, and connector routing matter on dual swing systems.
Before Ordering
- Confirm the operator model is PRO-SW3200XLS or a verified SW3000XLS dual-system secondary arm application.
- Match the cable length and connector style to the original arm.
- Inspect hinges, brackets, gate stops, and travel limits before installing the replacement.
- Verify the control board is sending output to the secondary arm before assuming the actuator is bad.
- Check whether the job needs mounting hardware, brackets, or only the arm.
Professional Advisory
Swing gate actuator replacement involves moving gates and pinch points. Disconnect power and follow the manufacturer service procedure. If the gate is heavy, binding, or unsafe, use a qualified gate technician.
Product Q&A
Is PROSW3200ARMXLS the primary arm?
No. It is commonly listed as the secondary arm for PRO-SW3200XLS dual swing gate systems.
Can this arm replace an SW3000XLS arm?
Only in the correct dual-system configuration. The SW3000XLS master and SW3200XLS secondary positions should be verified by the parts diagram.
Why does cable length matter?
The secondary actuator is normally farther from the control box. A short primary-arm cable may not reach or route correctly.
Will this fit SW4000XLS or SW4200XLS operators?
No, not as a direct assumption. The SW4000XLS/SW4200XLS family uses heavier-duty arm references and should be matched separately.
What should be checked before replacing the actuator?
Check the gate hinges, brackets, wiring, battery condition, board output, and physical actuator damage before replacing the arm.
