Liftmaster CPS Commercial Protector System for commercial and industrial photo-eyes.
Emitter-Receiver Type Photo-Electric Control.
The Liftmaster CPS Commercial Protector System provides protection on doors up to 45 feet wide. Contains emitter, receiver, mounting brackets, and operator interface. 24VAC, use CPS-L if Solid State Logic 3 or Medium-Duty Logic Control Board unit. OPEN only (all LiftMaster operators) after vehicle passes through infrared beam. Signal beam is projected across vehicle path and, when broken, sends a signal to open the door.
• NEMA 1 general purpose enclosure.
• Dual-sided infrared sensors.
• Indoor use.
• Maximum range of 30 feet.
• Solid sensor lights indicate correct sensor alignment.
• Yellow safety housing provides visibility for industrial environments.
UL 325 requires all commercial door operators to be either constant pressure to close or be equipped with a primary external monitored entrapment protection device. The CPS-U meets this requirement. Failure to use the appropriate sensor or failure to install the sensor properly, may expose the installer and customer to liability, should an accident occur.
- Weight: 2.0 lbs.
Technical Data Range
IP65, NEMA 4X
-20C° to +65C, -4F° to +149F°
2-wire, monitored, (polarized), 3ft.
1 Sender, 1 Receiver