My Account  |  0 item(s)    View Cart
Home > Linear Xtended Range Remote Kits > Linear Xtender Range Transmitter
Linear SST00083 XT-1 1-Channel Stationary Mid-range Transmitter 10W 27MHz
Linear SST00083 XT-1 1-Channel Stationary Mid-range Transmitter 10W 27MHz
Email a friend Email a friend
Add to Wish List Add to Wish List
Share |

Linear SST00083 XT-1 1-Channel Stationary Mid-range Transmitter 10W 27MHz

Item Id: LIN-XT1-SST00083
Review this item Review this item
Your Price: $201.00
Not for Sale
Choose Options
Antenna Range [Required for New Installations]
Linear SST00083 XT-1 1-Channel Stationary Mid-range Transmitter 10W 27MHz

The Model XT-1 1-Channel Stationary Mid-range Transmitter is designed for use in various wireless remote control applications. When triggered with an external switch, the Model XT-1 transmitter will send a 10 watt, 27.255 MHz, digital encoded, FSK modulated, signal to its companion receiver. The receiver will verify the digital code, activate its output, and trigger the remote device. 

The XT-1 transmitter has full supervision capabilities. If the status option is selected, the XT-1 sends hourly status signals to its receiver. If these signals cease, the receiver will indicate trouble by activating its status output after four hours. Contact supervision allows the receiver s output to follow the transmitter s input, staying activated as long as the transmitter input is activated. Alternately, an auto-restore option can be selected, causing a momentary receiver output each time the transmitter is activated. Either a N/O or N/C input (jumper selectable) can trigger the transmitter. 

Power for the XT-1 transmitter can come from an external regulated 12 VDC, 2-Amp power supply (Linear Model T-1224DC) or from a 12-volt battery. A 3-amp fuse protects the unit from reverse power polarity. The XT-1 draws about 15 µA standby, and about two amps during transmissions. If the power supply voltage drops below 10.5 volts, a low battery message will be included with any signal transmitted, causing the receiver s low battery output to activate. 

Two antennas (sold separately) are available for the XT-1. The Model ANT-1A is an 7-inch rubber duck antenna for short range applications (less than 1 mile). The ANT-1A is supplied with a CON-180A (straight) connector to mate the antenna to the transmitter. For a right angle antenna mounting, use a CON-90A right-angle connector with the CON-180A. The Model ANT-2 is a 3-foot whip antenna for use in long range or difficult installations where more range from the XT-1 is required. A common 9-foot 1/4 wave CB whip antenna can also be used with the XT-1 for maximum range. 

Two 8-position switches set the unit s system code. This code must be matched in the XT-1 s receiver. There are 65,536 different system codes possible. The 6-position option switch selects the transmitter s channel, receiver s bank (for XR-16 receiver only), and options for status and auto-restore transmissions. 

The transmitter is housed in a rugged weather-resistant metal enclosure with a sturdy SO-239 antenna connector and a water-tight wiring strain relief bushing. During transmissions, the red operation indicator (visible through a window on the case) lights. If the XT-1 s input voltage is low, the indicator will blink during transmissions.

Part Number: SST00083

Recently Viewed Items
Browse Similar Items