| WOR |
|---|
RADIO FREQUENCY |
| Frequency: | 318 MHz |
| Bandwidth: | 300 KHz minimum |
| Image Rejection: | 40 dB |
| LO Reradiation: | 200 µV/meter @3 meters (maximum) |
| Data Format: | MegaCode |
| Sensitivity: | -100 dB minimum |
| Desensitivity: | 20 dB manual attenuation at the antenna input |
INPUTS |
| Power: | Terminal block input + and Gnd ; input voltage 5 Vdc regulated or unregulated between +6 to +24 Vdc with reverse polarity protection |
| Hold: | Terminal block input Hold ; follows standard Wiegand hold line conventions; hold line can be overridden via dip switch |
| Antenna: | 9-1/2 in whip antenna with F-connector (supplied) |
OUTPUTS |
| Data: | Terminal block output Data 0 and Data 1 standard Wiegand electrical and protocol interface |
| LEDs: | Red RF activity LED indicates RF activity at 318 MHz; red/green decode LED is green during Wiegand data transmissions and receiver hold timing window (if enabled) after any output transmission; otherwise it is off unless hold enable is selected, in which case LED will remain red until hold is removed by host system |
CONTROLS |
| Pushbutton: | Momentary switch labeled Program used to configure microprocessor after system option selection and configuration |
DIP SWITCHES |
| Receiver Facility Code: | Four positions to select 1 of 16 possible MegaCode facility codes; if code 0 is selected, the receiver will validate any received facility code; any other selection requires the transmitters facility code to match the receiver facility code selection for validation |
| Output Facility Code: | 16 positions to select one of 65,536 possible facility codes; a selected output format may not use all 16 bits |
| Output Format: | 3 positions for selecting either 26, 30, or 31bit Wiegand output format |
| Button Disable: | 5 positions, each corresponding to 1 of 5 possible MegaCode transmitter buttons left or top left, right or top right, bottom left, bottom right, top |
| Receiver Lockout Disable: | 1 position; if set to ON, the 1 second receiver lockout is not performed |
| Button Offset: | 1 position; if set to ON, the transmitter ID number is offset with a number based on which button is pressed:| Button | Offset |
|---|
Left | 0 | Right | 16384 | Bottom Left | 32768 | Bottom Right | 49152 |
|
| Wiring: | up to 300 feet with 24 AWG, 500 feet with 20 AWG; up to 1,000 feet, CAT-5 |
| Enclosure: | Weather-resistant, anodized aluminum enclosure with removable end caps to provide wiring and programming access; end caps secured with screws |
| Operating Temperature: | -22° to +155° F (-30° to +70° C) |
| Electrical: | Robust RFI and ESD protection for all inputs and outputs, including antenna input; protection to prevent output errors during brownouts |
