The GTO SW2002XL will operate a gate up to 16’ long or weighing 500 lbs. (182 kg) each leaf; if all proper installation procedures have been followed. Ball bearing hinges
should be used on all gates weighing over 250 lbs (113.4 kg).
Includes battery backup, radio receiver, entry transmitter, AC transformer, and all necessary mounting hardware for a post mounted installation, 10” (25.4 cm) total offset.
The GTO 2002XL Operator is designed for installation on a pull-to-open dual leaf gate (gates that open into the property). By purchasing an accessory bracket, the GTO/PRO® 2002XL Operator can accommodate a push-to-open dual leaf gate (gates that open out from the property). The gate must not exceed 16 feet in length or weigh more than 500 pounds per leaf.
The GTO 2002XL Operator can be used on vinyl, aluminum, chain link, farm tube, and wrought iron gates. Use on solid (wood) gates is not recommended. Solid surface gates have a high resistance to the wind. If the wind is strong enough, the opener will obstruct and stop.
The GTO 2002XL Operator accommodates extra transmitters, digital keypads, solar panels, push buttons, automatic gate locks, and other access control products. These optional accessories are available at most stores. Your store should be able to special order any accessory not in stock. If your store cannot special order accessories.
The GTO 2002XL Operator features adjustable obstruction sensing. This safety feature makes the gate stop and reverse direction within 2 seconds when it comes in contact with an obstruction. MIN is the factory setting; meaning the gate will exert the minimum force on an obstruction before it stops and reverses direction.
The GTO 2002XL Operator also has an adjustable auto-close feature. After the gate reaches the fully open position, it can be set to remain open up to 120 seconds before automatically closing. Pressing the transmitter button at any time after the gate opens fully will cause it to close immediately. OFF is the factory setting; meaning the gate will stay open until you press the transmitter (or keypad, etc.) again.
