Product Overview
The GTO PRO-SW2002XLS is a dual swing gate operator package for compatible residential driveway gates with two moving leaves. It is commonly selected when a property has a double swing entrance and needs both gate leaves to open and close in a coordinated sequence. The system uses linear actuator arms tied into a 12V DC battery-backed control platform, making correct bracket geometry, hinge condition, gate balance, and charging setup very important for long-term performance.
This model is commonly listed for dual swing gates up to 16 ft per leaf and up to 500 lb per leaf when installed according to the manual. Those ratings assume a gate that swings freely, is properly supported, and is not dragging, twisting, or overloaded by wind load. Ball bearing hinges are commonly recommended on heavier gates, and the gate should be checked by hand before the operator is installed. A gate that is hard to move manually will shorten the life of the actuator and may create false obstruction or stall symptoms.
The PRO-SW2002XLS belongs to the XLS generation of GTO / Linear Pro swing gate equipment. That matters because older XL and newer XLS components can look similar but may not be electrically or mechanically interchangeable. When ordering replacement arms, boards, batteries, transformers, solar accessories, remotes, or safety devices, match the actual operator label and control board generation rather than relying only on a similar model name. Safety devices and warning signs must be installed for the actual gate opening and entrapment areas.
Compatible With
Dual vehicular swing gates in single-family residential applications when gate size, weight, hinges, post geometry, and safety layout match the PRO-SW2002XLS requirements. Commonly associated with GTO PRO-SW2002XLS, LPA 2002XLS, Linear PRO-SW2002XLS, PRO-SW2000XLS primary operator and second arm dual-gate package, and related GTO / Linear Pro XLS swing gate accessories. Common accessories include RB741/FM135 remotes, FM134/RB742 remotes, F310 keypad, F3100MBC wireless intercom keypad, FM122 solar panel kit where appropriate, compatible 12V battery, RB570 transformer family where specified, photo beams, gate locks, push buttons, and approved entrapment protection devices. Do not assume XL-series arms, boards, or harnesses interchange with XLS-series components.
Features and Specifications
| Manufacturer | GTO / Linear Pro |
|---|
| Product Type | Dual swing gate opener |
|---|
| Part Number | PRO-SW2002XLS |
|---|
| Application | Compatible dual vehicular swing driveway gates |
|---|
| Compatible Operator Type | 12V DC linear actuator swing gate system |
|---|
| Gate Capacity | Commonly listed up to 16 ft and 500 lb per leaf, when properly installed |
|---|
| Power Platform | 12V DC battery-backed system |
|---|
| Charging | Transformer or approved solar charging setup, not both at the same time |
|---|
| Related Models | PRO-SW2000XLS, LPA 2002XLS, SW2002XLS |
|---|
| Notes | Verify XL vs XLS generation before ordering replacement arms, boards, or harnesses. |
|---|
Also Known As / Related Part Numbers
PRO-SW2002XLS, SW2002XLS, GTO SW2002XLS, GTO PRO SW2002XLS, Linear PRO-SW2002XLS, Linear Pro SW2002XLS, LPA 2002XLS, PROSW2002XLS, 2002XLS, dual swing gate opener, GTO dual gate opener, Linear dual swing gate operator, XLS dual swing arm kit
Technician Note
If one leaf moves differently from the other, do not immediately assume the actuator is bad. Check gate swing, hinge drag, bracket geometry, battery voltage under load, arm harness condition, and control board settings. Dual systems depend on both leaves being mechanically sound.
Before Ordering Checklist
- Confirm the gate is a dual swing gate, not a single swing installation.
- Measure each gate leaf and estimate or confirm weight per leaf.
- Check hinge condition and use ball bearing hinges on heavier gates.
- Verify the actual operator label says XLS if ordering XLS replacement parts.
- Plan required entrapment protection, warning signs, and accessory wiring before installation.
Professional Advisory
Gate operator installation involves moving gates, stored battery power, low-voltage wiring, and safety device setup. Do not bypass safety inputs or operate a gate with missing required entrapment protection. For unsafe movement, electrical issues, or uncertain compatibility, use a qualified gate technician.
Product Questions and Answers
What type of gate is the PRO-SW2002XLS made for?
The PRO-SW2002XLS is intended for compatible dual vehicular swing gates in single-family residential applications, with each gate leaf properly hung and within the published size and weight range.
What gate size is commonly listed for the SW2002XLS?
The SW2002XLS is commonly listed for dual gates up to 16 ft per leaf and up to 500 lb per leaf when all installation requirements are followed.
Can I mix XL and XLS parts on this operator?
Do not assume XL and XLS arms, boards, or harnesses are interchangeable. XLS systems should be matched by exact part number, control board generation, and actuator type.
Can the SW2002XLS be charged by solar?
The 12V battery can be charged by an approved transformer or compatible solar charging kit where appropriate, but transformer and solar charging should not be connected at the same time.
Why do hinge condition and post geometry matter on this opener?
Poor hinges, sagging gates, incorrect brackets, or wrong geometry can overload the actuator and cause slow travel, obstruction faults, uneven gate movement, or premature wear.