GTO PRO-SW3200XLS Secondary Operator Compatibility and Technical Details
The GTO PRO-SW3200XLS is a secondary linear swing gate operator designed to work with a compatible PRO-SW3000XLS primary operator. Adding the SW3200XLS allows the primary system to control a second gate leaf in a dual residential vehicular swing gate installation.
The primary side contains the control board, battery, receiver, charging connections, accessory terminals, and system programming. The SW3200XLS operates as the second arm and connects back to the primary control system through the proper secondary-operator cable.
What This Secondary Operator Does
- Operates the second leaf of a compatible dual swing gate system
- Pairs with the GTO or Linear Pro Access PRO-SW3000XLS primary operator
- Uses a 12V DC linear actuator motor and screw-drive mechanism
- Supports the soft-start and soft-stop operation provided by the primary control system
- Supports pull-to-open installations with the standard system configuration
- May be used for push-to-open applications when the correct bracket and programming are used
- Allows properly equipped dual gates to operate from the same access controls and safety devices
Accessories Included
- Battery Backup
- 318 MHz Radio Receiver
- Entry Transmitter
- AC Transformer
- Mounting Hardware
Compatible With
- GTO PRO-SW3000XLS primary swing gate operator
- Linear Pro Access PRO-SW3000XLS primary operator systems
- Confirmed PRO-SW3000XLS and PRO-SW3200XLS dual swing gate installations
- Residential vehicular dual swing gates within the published capacity of the 3000XLS operator family
- Pull-to-open gate layouts using the correct mounting geometry
- Push-to-open layouts using the required R4388 push-to-open bracket for each applicable operator
Important Compatibility Warning
The PRO-SW3200XLS is not a universal secondary gate arm. It should be paired with the correct PRO-SW3000XLS primary operator, XLS-generation control board, secondary wiring, brackets, and limit-sensing components.
Do not assume that an older SW3200XL arm, a different GTO secondary operator, or a similar-looking Mighty Mule actuator will interchange. XL and XLS systems may use different control, limit, rev-counter, wiring, and mounting components. Verify the labels on the existing arm and control box before ordering.
Gate Application Requirements
The PRO-SW3000XLS and PRO-SW3200XLS system is intended for residential vehicular swing gates up to 16 feet long and 650 pounds per leaf when the gate is properly constructed, balanced, and installed. Each gate leaf must remain within the published rating.
The gate must swing freely through its complete travel without dragging, binding, twisting the post, or relying on the operator to support its weight. Ball-bearing hinges are recommended for gates weighing more than 250 pounds.
Features and Specifications
| Specification |
Details |
| Brand |
GTO PRO / Linear Pro Access |
| Part Number |
PRO-SW3200XLS |
| Product Type |
Secondary linear swing gate operator |
| Required Primary Operator |
PRO-SW3000XLS |
| Gate Configuration |
Dual residential vehicular swing gate |
| Maximum Gate Length |
Up to 16 feet per leaf |
| Maximum Gate Weight |
Up to 650 pounds per leaf |
| Operating Voltage |
12V DC through the compatible primary control system |
| Motor |
12V DC motor with planetary gear-drive system |
| Operator Style |
Linear actuator / screw drive |
| Approximate Opening Time |
Approximately 15 to 18 seconds, depending on gate and installation |
| Maximum Arm Stroke |
Approximately 16 inches |
| Operating Temperature |
Approximately -5 F to 160 F |
| Opening Direction |
Pull-to-open or push-to-open with the correct bracket and setup |
| Secondary Cable |
Commonly supplied with an approximately 40-foot connection cable; confirm package contents |
| Solar Capability |
Solar compatible when the complete system is properly sized and configured |
| Control Box |
Not included as part of a secondary-arm-only configuration |
| Application Class |
Residential vehicular gate applications |
| Package Contents |
Secondary operator and cable as specified by the seller; verify brackets, hardware, fasteners, and accessories |
Comparison With Similar GTO Operators
| Operator |
Application |
| PRO-SW3000XLS |
Primary operator with the main control system for a single gate or the primary leaf of a dual system |
| PRO-SW3200XLS |
Secondary operator for the second leaf of a PRO-SW3000XLS dual system |
| PRO-SW3200XL |
Earlier XL-generation secondary operator; not automatically interchangeable with XLS equipment |
| PRO-SW4200XLS |
Secondary operator for the heavier-capacity PRO-SW4000XLS operator family |
| Mighty Mule Secondary Arms |
Different residential operator families that should not be substituted without confirmed manufacturer compatibility |
Also Known As and Related Product Names
- GTO SW3200XLS
- GTO PRO-SW3200XLS
- Linear PRO-SW3200XLS
- Linear Pro Access SW3200XLS
- PRO SW-3200XLS
- 3000XLS secondary operator
- 3000XLS second gate arm
- SW3000XLS dual gate add-on arm
- GTO 3200XLS secondary actuator
Parts and Service Checks
A second gate leaf that stops operating does not always have a failed actuator. Before replacing the SW3200XLS, inspect the secondary cable, cable splices, terminal connections, control board output, battery condition, charging voltage, limit or rev-counter wiring, gate hinges, mounting geometry, and physical gate stops.
Intermittent operation may be caused by cable damage where the wiring crosses the driveway, corrosion inside a junction box, a weak battery, an improperly adjusted obstruction setting, or mechanical drag on the second gate leaf.
Before Ordering Checklist
- Confirm that the primary operator is labeled PRO-SW3000XLS.
- Verify that the required part is the secondary arm and not a complete dual system.
- Confirm the existing system is XLS and not an older XL generation.
- Inspect the secondary cable for cuts, underground damage, corrosion, or poor splices.
- Confirm the gate is no longer than 16 feet and no heavier than 650 pounds per leaf.
- Verify that each gate leaf swings freely by hand with the operators disconnected and power turned off.
- Confirm whether pull-to-open or push-to-open mounting is required.
- Order the R4388 push-to-open bracket when required for the installation.
- Confirm which brackets, fasteners, cable, and mounting hardware are included.
- Verify that the required photo eyes, safety edges, warning signs, and other entrapment protection are installed and operational.
Installation and Safety Notes
The SW3200XLS must be mounted with the correct bracket geometry so the operator does not bind, over-travel, or apply excessive force to the gate and posts. Dual gate sequencing must also be adjusted so the two leaves do not strike each other or interfere with an automatic gate lock.
This operator is intended for vehicular gates. Pedestrians should use a separate pedestrian entrance. Do not bypass photo eyes, safety edges, obstruction sensing, warning devices, emergency access equipment, or any other gate safety circuit.
Technician Note
When only the secondary leaf has stopped moving, test the operator cable and the secondary output from the primary control board before replacing the arm. A direct actuator replacement will not correct an underground cable fault, weak battery, failed board output, incorrect limit setup, or dragging gate.
Professional Advisory
Automatic swing gates can create serious entrapment and crush hazards. Installation, wiring, limit setup, force adjustment, gate sequencing, and safety-device testing should be completed by a qualified gate technician familiar with the GTO XLS operator platform and current gate safety requirements.
Local pickup in Hialeah Gardens, Florida may be available. Confirm current inventory and package contents before traveling.
Frequently Asked Questions
A: The PRO-SW3200XLS is the secondary/slave operator and must be paired with the PRO-SW3000XLS master operator to form a dual swing gate system.
Q: What is the maximum gate size the PRO-SW3200XLS can handle?
A: The PRO-SW3200XLS handles gates up to 16 ft long and up to 650 lbs per leaf.
Q: Is the PRO-SW3200XLS compatible with solar power?
A: Yes. The PRO-SW3200XLS is solar compatible and battery backup capable, making it suitable for remote or off-grid gate installations.
Q: How fast does the PRO-SW3200XLS open a gate?
A: The PRO-SW3200XLS opens and closes a gate leaf in approximately 15-18 seconds.
Q: What is the operating temperature range of the PRO-SW3200XLS?
A: The operating temperature range is -5 deg F to +160 deg F (-21 deg C to +71 deg C).
