The FTMT40 is the black front mount repair part used at the gate end of select larger Linear/GTO PRO SW4000-style swing gate actuator arms. This mount supports the actuator at the gate bracket and helps keep the arm pivot point properly aligned as the operator pushes and pulls the gate. It is commonly replaced when the front connection has been damaged, the pin area is worn, or the arm was stressed by a gate that was out of adjustment. The FTMT40 should be matched to the larger SW4000XL/SW4200XL family and not assumed to fit the smaller silver-mount actuator arms.
This replacement part is intended for restoring the original mechanical or control function of the listed Linear/GTO operator. Because older GTO PRO and Mighty Mule systems have several similar-looking model generations, match the part number, operator model, and original parts diagram before ordering. The same family name can include different arms, housings, control parts, brackets, or chain lengths depending on production year and single-gate or dual-gate layout.
Gate operator repairs should be performed with power disconnected and the gate secured so it cannot move unexpectedly. Do not bypass monitored safety devices, entrapment protection, limit components, or factory control wiring. If the gate is binding, the arm is bent, the slide chain is badly worn, or the operator has water or insect damage, have the full system inspected by a qualified gate technician before replacing only one part.
Yes. FTMT40 is commonly associated with the SW4000XL and SW4200XL style GTO PRO actuator arms.
No. FTMT40 and FTMT5030 are different front mount groups. Match the operator model and original part.
No. This is the front mount with pin. The full bracket set is a separate item such as HBP4XL where applicable.
