Product Overview
The HySecurity MX001403 Drive Belt Motor Pulley is a 24 tooth, 9 mm wide pulley that mounts to the motor input shaft on compatible HySecurity gate operators. It is used in the belt drive portion of the operator where motor rotation is transferred through the drive belt system.
A worn, loose, damaged, or incorrect pulley can cause belt tracking problems, belt wear, slipping, noise, uneven drive transfer, or poor operator performance. This part is commonly ordered when the existing motor pulley teeth are worn, the set screws no longer hold properly, or the belt drive assembly is being serviced.
This is a dimension-specific pulley. Tooth count, belt width, bore/input shaft fit, and set screw position must match the installed assembly. Similar HySecurity pulleys may look close but may not align correctly with the belt or companion pulley.
Compatible With
Common Applications
- Compatible HySecurity operators using the MX001403 24T, 9 mm motor-side drive belt pulley
- Motor input shaft pulley applications shown on matching HySecurity parts diagrams
Verification Notes
- Match tooth count: 24T
- Match belt width: 9 mm
- Confirm bore/input shaft fit and set screw placement
- Inspect related drive belt and companion pulley before ordering
Features and Specifications
| Manufacturer | HySecurity / Nice HySecurity |
|---|
| Product Type | Drive belt motor pulley |
|---|
| Part Number | MX001403 |
|---|
| Tooth Count | 24T |
|---|
| Pulley Width | 9 mm |
|---|
| Mounting Location | Motor input shaft |
|---|
| Included Components | Pulley with set screws |
|---|
Also Known As / Related Part Numbers
- MX001403
- HY-MX001403
- 24T motor pulley
- 9 mm drive belt pulley
- HySecurity motor-side belt pulley
- Pulley, motor, 24T, 9 mm
Technician Note
Replace or inspect the belt at the same time as the pulley. A worn belt can damage the new pulley, and a worn pulley can shorten belt life.
Before Ordering
- Confirm 24 tooth count and 9 mm belt width
- Match the motor input shaft and set screw arrangement
- Inspect belt condition and alignment
- Check companion pulley and belt tension
- Confirm the part on the operator parts diagram
Important Ordering Warnings
- Do not order by tooth count alone; shaft fit and belt width also matter
- Lock out power before servicing motor drive parts
Professional Advisory
HySecurity gate operator repairs often involve moving gates, stored energy, high voltage, batteries, and monitored safety devices. Electrical diagnosis and any unsafe gate movement should be handled by a qualified gate technician. Never bypass required entrapment protection or limit controls to keep an operator in service.
Product Questions and Answers
What is MX001403?
It is a 24 tooth, 9 mm drive belt pulley that mounts to the motor input shaft on compatible HySecurity operators.
Does it include set screws?
Common listings describe the pulley as including set screws.
Can this fix belt slipping?
It may help if the pulley is worn or loose, but belt condition, alignment, tension, and related pulleys should also be checked.
Is every 24T pulley interchangeable?
No. Belt width, shaft fit, pulley profile, and set screw placement must match.
Should the belt be inspected too?
Yes. Belt wear is one of the first things to check when replacing a motor pulley.