Liftmaster CPS Commercial Protector System for commercial and industrial photo-eyes.
Emitter-Receiver Type Photo-Electric Control.
The Liftmaster CPS Commercial Protector System provides protection on doors up to 45 feet wide. Contains emitter, receiver, mounting brackets, and operator interface. 24VAC, use CPS-L if Solid State Logic 3 or Medium-Duty Logic Control Board unit. OPEN only (all LiftMaster operators) after vehicle passes through infrared beam. Signal beam is projected across vehicle path and, when broken, sends a signal to open the door.
• NEMA 1 general purpose enclosure.
• Dual-sided infrared sensors.
• Indoor use.
• Maximum range of 30 feet.
• Solid sensor lights indicate correct sensor alignment.
• Yellow safety housing provides visibility for industrial environments.
UL 325 requires all commercial door operators to be either constant pressure to close or be equipped with a primary external monitored entrapment protection device. The CPS-U meets this requirement. Failure to use the appropriate sensor or failure to install the sensor properly, may expose the installer and customer to liability, should an accident occur.
Standard Specifications
DIMENSIONS
Length: (79mm/3.125").
Width: (42mm/1.625").
Height: (31mm/1.25"). Carton
Poly Bag
- Weight: 2.0 lbs. Technical Specifications Technical Data Range
Version: 9.1m/30ft. Indoor Rating
NEMA 1 Outdoor Rating
IP65, NEMA 4X Temperature Range
-20C° to +65C, -4F° to +149F° Terminal Interface
2-wire, monitored, (polarized), 3ft. Configuration
1 Sender, 1 Receiver Transmitter/Emitter
Sending Eye Receiver
Receiver Eye |
