Standard Specifications
DIMENSIONS
Photo Eye
Length: 1.6".
Width: 1.4".
Height: 3.8". Reflector
Length: 0.6".
Width: 2".
Height: 3.43. Technical Specifications Technical Data Range
13.7m/45ft. Angle of Adjustment
Min. 2 Degrees Min. Alignment Distance
36" (3 ft.) Outdoor Rating
IP65, NEMA 4X Temperature Range
-25 to +70C, -4°F – 158°F Terminal Interface
Monitored 2-Wire (Polarized) Color Code Sensors
Transmitter: Red LED
Receiver: Green LED | Quick Install Guide
PREPARE
Be sure to disconnect power to the operator BEFORE installing the photo eyes. The door MUST be in the fully opened or closed position before installing the photo eye. INSTALL
Set up the photo eye no higher than 6" (15 cm) above the floor and no farther than 6" from the center plane of the door. For installation ease, both photo eye and reflector should be on the same horizontal plane. COMPLETE
Make sure the photo eye is powered on properly. Adjust the photo eye and/or reflector until the alignment LED is off. For additional product information and installation procedures please see comprehensive installation manual inside the box. Wiring Connections
(Logic 4 board shown) 
|
