The HySecurity MX001754 is a replacement board-to-motor harness / motor plug reference for select HySecurity SlideSmart and SwingSmart applications. This harness helps connect the motor circuit to the operator control board or motor wiring interface, depending on the exact model and generation. It is typically ordered when the original plug is damaged, connector pins are loose or corroded, wiring is cut, or the operator has intermittent motor command issues caused by harness failure rather than a bad motor or controller. Because motor harnesses are highly fitment-sensitive, the part should be matched by MX001754 and the operator parts diagram. The connector layout, wire count, voltage platform, and routing must match the installed operator.
This is a service replacement part, so correct fitment matters more than the product name alone. HySecurity has used different assemblies across hydraulic slide operators, Smart DC operators, barrier operators, swing operators, and high-security crash products. Always compare the original part number, operator model, voltage or hydraulic configuration when applicable, connector or fitting style, and the factory parts diagram before ordering.
This part may be used with the following HySecurity applications when the installed operator and parts diagram confirm the match:
Compatibility should be verified before installation. Similar HySecurity parts may look close but differ by connector, hose length, switch geometry, voltage rating, gear size, lock cylinder, or operator generation.
| Manufacturer | HySecurity / Nice HySecurity |
|---|---|
| Product Type | Motor plug / board-to-motor harness |
| Part Number | MX001754 |
| Application | Motor wiring connection |
| Compatible Operator Type | Select SlideSmart and SwingSmart references |
| Included Components | Harness/plug assembly unless otherwise stated |
| Notes | Match connector and control platform |
Before replacing this part, inspect the surrounding assembly for the condition that caused the failure. Worn pivots, loose hardware, incorrect routing, damaged wiring, leaking hydraulic fittings, bad mating gears, or a changed lock cylinder can make the replacement part appear incorrect or cause repeat failures.
Do not bypass limit switches, monitored safety devices, covers, lock hardware, or required safety circuits to keep a gate running. If the operator moves unpredictably, overtravels, leaks hydraulic oil, trips protection, or has damaged wiring, the system should be inspected and repaired before being returned to service.
It is used as a motor plug or board-to-motor harness on select HySecurity SlideSmart and SwingSmart operator applications.
Only if the problem is the harness or connector. Motor, controller, encoder, power supply, and wiring faults can create similar symptoms.
The exact compatible platform must be confirmed by model and parts diagram. Do not assume it fits every Smart operator.
Motor wiring can vary by voltage, motor type, and controller generation. A similar-looking plug may have different pinout or conductor routing.
Yes. Electrical service should be performed with proper lockout and by a qualified technician, especially around motor and power wiring.