Gate plate tube spacer for Linear SWC/SWR/SWD swing gate operator installation. The Linear 2200-964 is an OEM replacement gate plate spacer designed for use with Linear and OSCO gate operator systems. This part is compatible with Linear SWC swing gate operator, Linear SWR swing gate operator, Linear SWD swing gate operator systems. Always verify compatibility with your specific operator model before installation.
| Feature | Specification |
|---|---|
| Model | Linear 2200-964 |
| Item Type | Gate Plate Spacer |
| Mounting | Welded or bolted to gate |
A: The spacer positions the gate plate tube at the correct height relative to the operator, maintaining the required 24-7/8-inch distance between the top of the operator pad and the gate plate mounting point for proper arm geometry.
A: The installation manual for the SWR/SWC/SWD operators states the gate plate should be mounted 24-7/8 inches above the top surface of the operator pad. The spacer helps achieve this dimension.
A: According to Linear installation documentation, the gate plate can be either welded or bolted to the gate, depending on the gate construction and installer preference. Welding provides a more permanent connection while bolting allows future adjustment.
A: Check the spacer and gate plate for corrosion, physical damage, loose fasteners, and proper alignment. Misalignment of the gate plate spacer can cause binding or uneven stress on the operator arm and pivot hardware.
A: An incorrectly positioned gate plate spacer can cause the operator arm to bind at the extremes of travel, place side-load stress on the operator output shaft, and result in erratic gate movement or premature mechanical wear.