The BEA 10MICROCELL1D is part of the BEA Microcell infrared safety beam family for automatic pedestrian doors. Microcell beams use compact cylindrical emitter and receiver heads that can be integrated into door frames, thresholds, or swing door guide rail areas where a low-profile safety beam is required. This item is the double Microcell version supplied for 5 meter / approximately 18 ft cable. It is selected when the door system needs a focused infrared beam safety input rather than a wide-area presence sensor.
This standard cabled version is commonly used when a complete Microcell double safety beam set is needed for a pedestrian automatic door. Replacement is common when beam heads are damaged, cable jackets are cut, the control box output fails, or door safety testing shows unreliable beam response. Cable length and single-versus-double beam layout matter because a 5 meter set, a 10 meter set, a single-beam set, and a double-beam set serve different physical openings.
Compatibility should be verified by the original BEA part number, product family, voltage, loop count, cable length, and the equipment wiring diagram. Commonly associated applications include:
| Manufacturer | BEA Sensors |
|---|---|
| Product Type | Infrared safety beam |
| Part Number | 10MICROCELL1D |
| Series / Family | BEA Microcell |
| Application | Automatic pedestrian sliding door thresholds and swing door guide rail safety |
| Beam Configuration | Double beam |
| Cable Length | 5 meter / approximately 18 ft cable |
| Sensor Style | Compact cylindrical emitter and receiver heads |
| Mounting | Designed for integration into door frames, profiles, thresholds, or guide rails where appropriate |
| Hole Size Reference | Fits easily into 1/2 inch pre-drilled holes in compatible applications |
| Output / Control | Used with Microcell control box and compatible automatic door safety input |
| Notes | Verify beam count, cable length, and adapter requirements before ordering |
Confirm whether the door uses a double beam layout before ordering this part. Also compare the required cable length and whether the job is a standard cabled Microcell installation or an Optex retrofit adapter installation. Similar Microcell part numbers can differ only by one letter, cable length, or single/double beam configuration.
Automatic pedestrian door safety beams should be installed, aligned, and tested by a qualified automatic door technician. After service, test the door through the full opening and closing cycle and confirm the safety input responds correctly to beam interruption.
The 10MICROCELL1D is a double Microcell product. Match it to the original beam layout before ordering.
They are commonly used on automatic sliding pedestrian door thresholds and automatic swing door guide rail safety applications.
Yes. Microcell versions are offered with different cable lengths, and the cable must suit the door frame routing and control box location.
Some BEA Microcell adapter kits are intended for Optex photo beam retrofit applications. Use the adapter version only when the retrofit layout and instructions match the existing installation.
Check beam alignment, wiring, control box output, door response, and required safety testing before returning the automatic door to service.