The HySecurity MX5101-04 is an electrical enclosure assembly used in select Nice HySecurity SlideDriver II SD200V gate operator applications. It supports the operator's control and power compartment where the current parts diagram calls for this assembly.
This enclosure is tied to 3PH, 208-230VAC. It should not be selected for another SlideDriver II model, phase, voltage, DC, UPS, or export configuration unless HySecurity documentation confirms the same part number.
The electrical enclosure assembly houses or supports control and power components such as controller hardware, wiring harnesses, terminals, contactors, power supply components, grounding points, labels, and covers depending on the current package configuration.
This assembly may be used with select HySecurity SlideDriver II SD200V applications where the current parts diagram lists MX5101-04.
Do not confuse MX5101-04 with MX5100-02 and MX5101-01. SlideDriver II enclosures vary by model size, phase, voltage, controller generation, harness routing, and included components.
If the enclosure was damaged by water, heat, surge, insects, loose wiring, or a failed component, diagnose the cause before installing the replacement assembly.
| Part / Item | Typical Use | Interchange Caution |
|---|---|---|
| MX5101-04 | Electrical enclosure assembly for SD200V 3PH, 208-230VAC | Correct where the parts diagram lists MX5101-04 |
| MX5100-02 | SD15 and SD40 1PH enclosure | Related smaller-model assembly, not automatically the same |
| MX5101-01 | SD50F and SD80V 1PH 208-230VAC enclosure | Different from SD15/SD40 and SD200V 3PH versions |
| MX5101-04 | SD200V 3PH 208-230VAC enclosure | Different phase/model configuration |
| Specification | Details |
|---|---|
| Manufacturer | HySecurity / Nice HySecurity |
| Part Number | MX5101-04 |
| Product Type | Electrical enclosure assembly |
| Operator Family | SlideDriver II |
| Model Application | SD200V |
| Phase / Voltage | 3PH, 208-230VAC |
| Assembly Area | Electrical/control enclosure area |
| Package Contents | Verify whether enclosure, covers, mounted components, harnesses, labels, and hardware are included |
Electrical enclosure assemblies are not generic boxes. The harness layout, power component arrangement, grounding, and controller support must match the exact operator configuration.
Disconnect and lock out power before servicing the enclosure. Label wiring before removal. High-voltage gate operator work should be performed by a qualified gate technician or electrician. After installation, test limits, inputs, outputs, loops, access control, and safety devices.
Do not bypass fuses, disconnects, monitored entrapment devices, photo eyes, safety edges, grounding, or controller protections to keep the operator running. Unsafe wiring or voltage issues should be corrected before continued use.
The HySecurity MX5101-04 is a electrical enclosure assembly used in select SlideDriver II SD200V applications where the current HySecurity parts documentation confirms this part number.
No. HySecurity parts are model, generation, voltage, phase, and configuration sensitive. Verify the operator model, serial number, and current parts diagram before ordering.
The biggest mistake is ordering the wrong enclosure by appearance instead of matching model, phase, voltage, controller generation, harness layout, and current parts diagram.
Yes. Check related wiring, harnesses, hydraulic components, sensors, mechanical load, controller faults, and safety inputs as applicable before replacing the part.
This part is intended for qualified gate technicians or properly trained service personnel, especially when the repair involves high voltage, hydraulics, controller wiring, or commercial gate safety systems.
No. Do not bypass photo eyes, safety edges, loops, emergency access, fire access, monitored entrapment devices, disconnects, or operator safety circuits to make the gate run.