The HySecurity MX5106 is a 120W 24VDC power supply used in select Nice HySecurity operator electrical assemblies. It provides low-voltage DC power for compatible controller and accessory circuits where the system documentation calls for this part.
Power supplies are voltage and configuration sensitive. The uploaded title identifies this item as 115V input, and HySecurity documentation ties MX5106 to 1PH input power applications. Confirm the actual operator and input voltage before ordering.
This power supply converts the appropriate AC input into 24VDC power for supported operator control circuits. A failed or incorrect power supply can cause controller resets, dead displays, low-voltage faults, accessory problems, or intermittent operation.
This part may be used with select HySecurity operator electrical assemblies where the parts documentation lists MX5106.
Do not assume MX5106 replaces every HySecurity 24VDC power supply. HySecurity documentation also references MX4097 for other 120W 24VDC applications, including certain 3PH/VFD configurations. Match the exact part number and operator configuration.
Before replacing the power supply, check input power, fuses, shorts on 24VDC accessories, controller wiring, surge exposure, grounding, and water intrusion.
| Part / Item | Typical Use | Interchange Caution |
|---|---|---|
| MX5106 | 120W 24VDC power supply for select 1PH applications | Correct where parts documentation lists MX5106 |
| MX4097 | 120W 24VDC power supply for other HySecurity configurations | Not automatically interchangeable |
| Controller boards | SmartTouch or SmartCNX logic boards | Not a power supply replacement |
| Specification | Details |
|---|---|
| Manufacturer | HySecurity / Nice HySecurity |
| Part Number | MX5106 |
| Product Type | Power supply |
| Output | 24VDC |
| Power Rating | 120W |
| Input Note | 115V / 1PH input application as listed; verify exact operator documentation |
| Compatibility Caution | Do not substitute for MX4097 or other power supplies without documentation |
A dead controller does not automatically mean a bad controller. On HySecurity systems, verify AC input, power supply output, fuses, grounding, and shorted 24VDC accessories before replacing MX5106.
Disconnect and lock out power before servicing the power supply. High-voltage and low-voltage wiring should be handled by qualified personnel. After replacement, verify proper 24VDC output and test the operator, controller, accessories, and safety devices.
Do not bypass fuses, disconnects, power supply protections, safety inputs, or monitored entrapment devices. If voltage readings are unclear or wiring is damaged, use a qualified gate technician or electrician.
The HySecurity MX5106 is a 120W 24VDC power supply used in select HySecurity operator electrical assemblies applications where the current HySecurity parts documentation confirms this part number.
No. HySecurity parts are model, generation, voltage, phase, and configuration sensitive. Verify the operator model, serial number, and current parts diagram before ordering.
The biggest mistake is ordering MX5106 without confirming input voltage and whether the operator actually requires MX5106 instead of MX4097 or another HySecurity power supply.
Yes. Check related wiring, harnesses, hydraulic components, sensors, mechanical load, controller faults, and safety inputs as applicable before replacing the part.
This part is intended for qualified gate technicians or properly trained service personnel, especially when the repair involves high voltage, hydraulics, controller wiring, or commercial gate safety systems.
No. Do not bypass photo eyes, safety edges, loops, emergency access, fire access, monitored entrapment devices, disconnects, or operator safety circuits to make the gate run.