12-Lug 24V Barrier Terminal Strip for Genie Commercial Door Operators. Genuine Genie OEM replacement part number 075137.0000.S designed for Genie commercial door operators. Rated for 24V DC control circuit rated operation. Consult your operator service manual or contact Genie commercial parts support with your model and serial number to confirm fitment.
| Feature | Specification |
|---|---|
| Model | Genie 075137.0000.S |
| Item Type | Terminal Strip (12 Lug, 24V, B) |
| Voltage | 24V DC control circuit rated |
| Contact Configuration | 12-lug barrier-type terminal strip, single-row, screw-terminal connections |
| Mounting | Panel-mount or DIN-rail compatible - verify against specific operator control board mounting provisions |
| Alternate Part Numbers | 075137, 075137.0000, 075137-S |
| Replaces / Superseded Part Numbers | 075137, 075137.0000 |
A: The 'B' designation in '24V B' most likely refers to a barrier-type terminal strip construction, which uses dividers between each lug to prevent accidental bridging of adjacent conductors. It may also indicate a B-circuit or secondary control circuit board assignment within the operator.
A: This terminal strip is rated for 24V control circuits. Do not use it on line-voltage (120V or higher) wiring runs. It is intended for low-voltage control, safety device, and accessory wiring within Genie commercial operator enclosures.
A: The 075137 prefix is associated with an older Genie commercial operator part numbering system. Customers should verify with a Genie authorized distributor whether a current replacement cross-reference exists, such as a part in the 107910 series or a comparable 12-position terminal strip.
A: A 12-lug terminal strip provides 12 individual screw-terminal connection points, allowing up to 12 separate control wires - such as inputs from safety edges, photo eyes, push buttons, access control devices, and limit switch circuits - to be landed on a single organized strip.
A: Barrier terminal strips of this type typically accept 14 AWG to 22 AWG stranded or solid copper control wire. Consult the specific Genie operator wiring diagram for recommended wire gauge for each circuit.