Flexible silicone push-on sealing cap, .040 in (.040 inch) inside diameter, for sealing or insulating small wire terminations, sensor leads, or pin connectors in Genie commercial door operator systems .040 in inside diameter sized for small wire terminations, sensor leads, and pin connectors found in Genie operator wiring harnesses. Flexible silicone material maintains seal and insulation across wide temperature and environmental ranges. Push-on installation requires no tools, adhesives, or special preparation.
| Feature | Specification |
|---|---|
| Model | 111383.0001.S |
| Item Type | Silicone Sealing Cap |
| Contact Configuration | Single-opening push-on cap; no electrical contacts; seals over wire end, pin, or small terminal |
| Enclosure Rating | Not applicable as a standalone enclosure; silicone material provides moisture and environmental resistance at the termination point |
| Materials | Flexible silicone elastomer |
| Dimensions | .040 in (approximately 1.02 mm) inside diameter; overall length and wall thickness not confirmed |
| Mounting | Push-on; applied by hand over wire end, pin, or small terminal; retained by silicone elasticity |
| Alternate Part Numbers | 1113830001S, 111383-0001-S |
A: The .040 in dimension refers to the inside diameter of the cap opening. This is the nominal size of the wire, pin, or terminal the cap is designed to fit over. Silicone's inherent flexibility allows it to stretch slightly to grip terminations at or near this diameter, providing a secure, sealed fit.
A: Silicone is used because it remains flexible across a wide temperature range, resists moisture, oils, and many chemicals, provides electrical insulation, and does not become brittle with age as readily as PVC or rubber alternatives. These properties make it well suited for protecting small terminations in commercial door operator environments.
A: Installation is a simple push-on process. The cap is pushed onto the wire end, pin, or connector until fully seated. No tools or adhesives are required. The inherent elasticity of the silicone provides retention and sealing pressure.
A: Confidence on this part is rated low. The exact Genie operator models and specific wiring harness locations where this cap is used have not been confirmed. Refer to the operator service manual wiring diagrams or contact Genie technical support with the operator model and serial number to confirm the correct application.
A: The cap provides electrical insulation to prevent short circuits at exposed wire ends or pins, and environmental sealing to prevent moisture ingress or contamination at small terminations. This is particularly important for sensor leads and low-voltage control wiring that may be exposed to wash-down, dust, or condensation in commercial door operator environments.