The HySecurity MX001644 motor assembly is a 2 HP, single-phase 50Hz service motor rated at 2850 RPM. It is used where a compatible HySecurity gate operator was built for a 50Hz electrical supply. This distinction matters because 50Hz and 60Hz motors do not always interchange safely or perform the same way under hydraulic load. A motor with the correct horsepower but the wrong phase, voltage, frequency, or RPM can create starting problems, heat, nuisance trips, and poor gate operation. Public data supports the core motor specification, but broad model-by-model compatibility is limited, so this product should be treated as an exact-part replacement. Confirm the original motor tag, operator serial number, and HySecurity parts diagram before ordering.
Common service reasons may include motor failure, heat, noise, damaged leads, worn hydraulic seals, missing hardware, limit-reference errors, or other symptoms tied to the specific part type. Always diagnose the operator first so the replacement part corrects the actual problem.
This part may be used with the following HySecurity applications when confirmed by part number, operator model, serial number, voltage package, and parts diagram:
| Feature | Specification |
|---|---|
| Manufacturer | HySecurity / Nice HySecurity |
| Product Type | Electric motor assembly |
| Part Number | MX001644 |
| Horsepower | 2 HP |
| Phase | 1-phase |
| Frequency | 50Hz |
| Speed | 2850 RPM |
| Application | Compatible HySecurity 50Hz operator configurations |
| Compatible Operator Type | Exact-part replacement where MX001644 is shown in the parts diagram |
| Notes | Do not substitute for 60Hz, 3-phase, or 24VDC motors without HySecurity documentation |
The following numbers and phrases are related search references, catalog aliases, or commonly associated part-number formats. Confirm whether a related number is an exact replacement before ordering.
Do not select HySecurity service parts by appearance alone. Similar operators can use different motors, switches, manifolds, seals, voltages, phases, frequencies, horsepower ratings, or hardware revisions. Match the original part number and the operator parts diagram before replacing components.
Gate operators can move heavy gates and may contain high-voltage wiring, stored hydraulic pressure, and monitored safety circuits. Do not bypass safety devices, limit switches, entrapment protection, or factory wiring. If the operator moves unpredictably, has missing safety devices, leaks hydraulic fluid, or requires electrical diagnosis, have the system inspected by a qualified gate technician.
Match the original HySecurity part number, horsepower, voltage, phase, frequency, RPM, shaft/coupler setup, and operator parts diagram. Do not substitute a similar motor only by physical size.
Yes. This listing is written around the 50Hz, 2 HP, 1-phase, 2850 RPM specification shown for MX001644. Frequency matters because motor speed, current draw, and heat can change if the wrong motor is used.
It may be used in place of MX001644 only when the operator configuration and parts diagram support that substitution. Check the existing nameplate and HySecurity part reference before ordering.
This motor is commonly associated with HySecurity 50Hz operator configurations that call for this exact 2 HP motor. Exact use depends on the operator model, voltage package, phase, and production generation.
Yes for most commercial hydraulic gate operators. Motor replacement can involve high voltage, hydraulic pump coupling alignment, and safety-device checks, so a qualified gate technician should handle unsafe or unfamiliar work.