HySecurity MX3416, BRACKET, TARGET MAGNET
The HySecurity MX3416 is a target magnet bracket used in the WedgeSmart DC wedge barrier system. It provides the magnet/target point that the operator uses as part of the wedge position sensing arrangement, helping the control system identify the position of the wedge plate during operation.
Correct target location is important. If the bracket is bent, loose, missing, or installed out of alignment, the operator may have trouble confirming position, may show limit or target faults, or may not operate reliably. MX3416 should be matched to WedgeSmart DC parts diagrams and installed so the target sensor relationship is restored to the factory layout.
Compatible With
- HySecurity WedgeSmart DC wedge barrier systems where the parts diagram calls for MX3416.
- WedgeSmart DC chassis, drive, and electrical diagrams listing Bracket, Target Magnet.
- WedgeSmart DC wedge plate target sensing applications.
- Used with related WedgeSmart target sensor components where the diagram identifies the bracket/magnet target.
- Not a general-purpose gate magnet, limit switch, or standalone safety sensor.
Features and Specifications
| Manufacturer | HySecurity / Nice HySecurity |
|---|
| Part Number | MX3416 |
|---|
| Product Type | Target magnet bracket |
|---|
| Primary Application | Replacement bracket and magnet target for WedgeSmart DC wedge plate sensing |
|---|
| Compatible Operator Type | Crash wedge / WedgeSmart DC applications |
|---|
| Handing / Size / Rating | Bracket and magnet used as wedge plate target. |
|---|
| Included Components | Target magnet bracket assembly as supplied by manufacturer. |
|---|
| Notes | Sensor target alignment is important for reliable wedge position detection. |
|---|
Also Known As / Related Part Numbers
- MX3416
- MX 3416
- MX3416 target magnet bracket
- Bracket, Target Magnet
- Wedge plate target bracket
- WedgeSmart DC target magnet bracket
- HySecurity WedgeSmart DC wedge plate target
Technician Note
After replacing the target magnet bracket, verify sensor alignment and operator feedback through a normal service test. A good bracket will not correct a failed sensor, damaged wiring, or incorrect limit setup.
Before Ordering
- Confirm the WedgeSmart DC diagram lists MX3416.
- Inspect the old target bracket for bending or missing magnet.
- Check the target sensor and wiring at the same time.
- Verify bracket mounting and sensor gap before cycling the wedge.
- Run a controlled operational test after service.
Professional Advisory
Installation and service on automated gate equipment should be performed by a qualified gate technician. Do not bypass safety devices, breakaway switches, monitored edges, or photo eyes to make a gate run.
Product Questions and Answers
What is HySecurity MX3416 used for?
HySecurity MX3416 is used as a target magnet bracket in replacement bracket and magnet target for wedgesmart dc wedge plate sensing. It should be selected by the exact part number and the operator parts diagram.
Is MX3416 compatible with all HySecurity operators?
No. MX3416 should only be used with the HySecurity operator families and assemblies that list this part number or an approved related number in the parts diagram.
What should I check before ordering MX3416?
Check the original part number, operator model, serial number, production date when relevant, and the physical style of the old part. Also inspect nearby hardware or wiring that may have caused the failure.
Can I install MX3416 myself?
Mechanical parts should be installed only by someone familiar with automated gate equipment. Electrical parts and safety-related repairs should be handled by a qualified gate technician.
Are there related part numbers for MX3416?
Yes. See the Also Known As / Related Part Numbers section on this page. Related numbers may describe opposite-hand parts, newer or older harnesses, companion parts, or search variations and are not always direct replacements.
