Linear 2110-067-BT, Enclosure W/O Door GSWG SWG Blk Tex
The Linear 2110-067-BT is a replacement operator enclosure shell for select Linear / OSCO SWG and GSWG swing gate operator cabinets. It is supplied as an enclosure without the door, making it useful for cabinet rebuilds where the main housing is damaged but the door and internal operator components are being reused or ordered separately.
Operator enclosures do more than hold parts in place. A sound cabinet helps protect the motor, control box, limit components, wiring, and mechanical drive parts from weather, debris, and tampering. If an enclosure is rusted through, cracked, or no longer seals correctly, internal component failures can continue even after the electrical parts are replaced.
Because SWG and GSWG cabinet parts can vary by generation and configuration, this part should be confirmed by the service parts diagram and not by cabinet color alone.
Compatible With
This enclosure is for select SWG/GSWG cabinet applications. Match the part number to the operator parts diagram before ordering.
- Select Linear / OSCO SWG swing gate operator applications
- Select Linear / OSCO GSWG swing gate operator applications
- Select VS-GSWG operator cabinet applications where 2110-067-BT is listed
- Cabinet rebuilds requiring the black textured enclosure without door
- Not intended for HSLG, SLG, BG, BGU, or unrelated Linear operator cabinets unless specifically shown in the parts diagram
Features and Specifications
| Manufacturer | Linear / OSCO |
|---|
| Product Type | Replacement operator enclosure |
|---|
| Part Number | 2110-067-BT |
|---|
| Application | Select SWG and GSWG swing gate operator cabinets |
|---|
| Material / Finish | Black textured finish |
|---|
| Included Components | Enclosure without door |
|---|
| Compatible Operator Type | Commercial swing gate operator cabinet service part |
|---|
| Notes | Internal components, door, lock, hardware and wiring are not included unless stated |
|---|
Also Known As / Related Part Numbers
- 2110-067-BT
- LIN-2110-067-BT
- 2110-067
- Enclosure W/O Door GSWG SWG Blk Tex
- GSWG enclosure
- SWG enclosure
- VS-GSWG enclosure
Technician Note
When replacing an enclosure, check conduit entry points, grounding, drain paths, and the condition of reused door hardware. A clean enclosure install helps prevent future water and corrosion damage.
Before Ordering
- Confirm the operator series is SWG, GSWG or a listed VS-GSWG configuration
- Verify the existing door and lock are reusable or order the correct matching door
- Compare mounting points and conduit locations
- Inspect internal components for water or rust damage
- Plan for safe disconnect of power before any cabinet work
Professional Advisory
Moving internal operator components from one enclosure to another can involve high-voltage wiring and should be handled by a qualified gate technician.
Important Ordering Warnings
- This enclosure is supplied without the door
- Not a universal cabinet for all Linear / OSCO operators
- Do not reuse damaged grounding or wiring hardware
- Cabinet replacement does not correct underlying electrical or mechanical operator problems
Product Questions and Answers
Does the 2110-067-BT include the enclosure door?
No. It is listed as an enclosure without door.
What operators is this enclosure commonly used with?
It is commonly associated with select Linear / OSCO SWG, GSWG and VS-GSWG swing gate operator cabinet applications.
Can this enclosure be used on a slide gate operator?
Not unless the exact part number appears in that operator's parts diagram. It is primarily associated with SWG/GSWG swing operator cabinets.
Does this include the control board or motor?
No. This is a cabinet enclosure service part only.
Why should the cabinet be replaced instead of only replacing electronics?
A damaged enclosure can allow water, insects, corrosion, and poor grounding conditions that may cause repeat failures.
