Linear 2200-929 is a v-belt manufactured by Linear/OSCO for use in their gate operator product line. 4L x 24 in Cogged V-Belt for Linear Gate Operators. Constructed from Rubber with fiber cord reinforcement. 24 in nominal outside circumference, 4L cross section. Belt drive - routed over matched V-belt pulleys.
A: A cogged or molded-notch V-belt has transverse notches on the inner surface that reduce bending resistance, improve flexibility, and allow it to run on smaller-diameter pulleys with less heat buildup.
A: The 4L designation is a standard fractional horsepower V-belt cross section with a top width of approximately 1/2 in and a depth of approximately 5/16 in.
A: The nominal outside length of the belt is 24 in, which corresponds to a standard 4L240 belt designation in industry nomenclature.
A: Cogged V-belts are typically made from EPDM or neoprene rubber with polyester or aramid fiber cord reinforcement for tensile strength.
A: The belt should be inspected at each maintenance interval for cracking, glazing, fraying, or loss of tension, and replaced when any of these conditions are found.
