The Linear 2510-222 is a loop wire kit designed as an OEM replacement component for Linear and OSCO gate operators. This 200 ft vehicle detector loop wire kit with two tubes of joint sealant for inductive loop installations ensures reliable operation and meets the original equipment specifications. Compatible with Linear/Nice vehicle loop detector installations, OSCO loop detector systems, Any standard saw-cut inductive loop detector installation requiring loop wire and sealant, it is engineered for direct installation without modification. Use only genuine OEM replacement parts to maintain system safety certification and warranty coverage.
A: The kit contains 200 ft of loop detector wire and two tubes of sealant for sealing the saw cut after wire installation.
A: The sealant is used to fill and seal the saw-cut slot in asphalt or concrete after the loop wire is placed, protecting the wire from moisture, traffic, and debris.
A: Loop wire is wound in the saw-cut slot in the roadway, with a twisted lead-in run to the loop detector. The sealant is then applied over the wire to fill the slot flush with the road surface.
A: 200 ft of wire is typically sufficient to wind a standard single-lane detection loop with multiple turns plus run the twisted lead-in back to the detector enclosure, but available wire length depends on loop size and lead-in distance.
A: The wire is specified for inductive vehicle detection loop use. Refer to the Linear/Nice installation guide for the recommended AWG gauge and insulation type for this kit.
