Marantec 84284, Logic Board for Mline and Qline
The Marantec 84284 logic board is a model-specific electronic control part for select DC2500, DC3700, M4500, M4700, Q7500 and Q7700 applications. A failed board can make the opener act like it has a bad remote, wall button, motor, reference switch, or safety sensor, so the part should be confirmed before replacement. The safest way to order is by matching the operator model, original board number, connector layout, and any visible revision markings. This is especially important on Marantec units because 84284, 84285, 97798, 104081, and 104082 appear in related searches but are not automatically interchangeable.
Compatible With
- Marantec DC2500
- Marantec DC2500e
- Marantec DC3700
- Marantec DC3700e
- Marantec M4500
- Marantec M4700
- Marantec Q7500
- Marantec Q7700
- Select D-Line, M-Line, and Q-Line openers where the original board number and connector layout match
- Not for M4500E or M4700E models that use the 97798 board family
Features and Specifications
| Manufacturer | Marantec |
|---|
| Product Type | Logic control board / service kit |
|---|
| Part Number | 84284 |
|---|
| Application | select DC2500, DC3700, M4500, M4700, Q7500 and Q7700 applications |
|---|
| Compatible Operator Type | Select Marantec residential garage door openers |
|---|
| Programming | Remote/keypad and opener setup may be required |
|---|
| Safety Monitoring | Must remain connected to the required photo eye/safety system |
|---|
| Notes | Match board label and connector layout |
|---|
Also Known As / Related Part Numbers
- 84284
- Marantec 84284
- Marantec logic board
- Marantec control board
- Related search references: 84284, 84285, 104081, 104082, 97798
- Do not assume interchange without model and board confirmation
Technician Note
If the original board failed from a surge, water intrusion, shorted accessory, or damaged wiring, correct that problem before installing the replacement board.
Before Ordering
- Confirm the opener model number.
- Compare the original board number and terminal layout.
- Inspect wiring, accessories, and photo eyes before replacing the board.
- Plan to reprogram remotes and keypads.
- Do not choose by appearance only.
Important Ordering Warnings
- Do not bypass safety photo eyes to make the opener run.
- Disconnect power before service and use a qualified technician for electrical diagnosis.
- Do not substitute a similar board unless the model and board label support it.
Professional Advisory
For electrical diagnosis, internal opener repair, unsafe door movement, or repeated part failure, use a qualified garage door technician. Do not bypass photo eyes, safety circuits, or factory protections to make an opener run.
Questions and Answers
Which opener is Marantec 84284 used with?
It is commonly listed for DC2500, DC2500e, DC3700, DC3700e, M4500, M4700, Q7500, and Q7700 models.
Is Marantec 84284 interchangeable with nearby board numbers?
No. Similar Marantec boards can have different model fit, connector layout, programming, and safety input behavior. Match the original board label.
Will remotes need to be reprogrammed?
In many cases, remotes and keypads must be programmed again after board replacement.
What should be checked before ordering?
Match the opener model, original board number, connector layout, photo eye setup, and board revision.
What symptoms can point to a failed logic board?
No response from controls, lost radio programming, erratic operation, travel errors, or accessory input problems can point to a board issue, but power and safety circuits should be checked first.
