The Genie 110340.0001.S is a preformed inductive detection loop designed for paveover installation in a 4 ft x 6 ft detection zone. In the paveover installation method, the loop assembly is placed on the existing pavement surface and permanently embedded under a new layer of asphalt or concrete. The 18 AWG wire leads provide a 2-wire output connection to the 112723 loop detector. This loop is factory-preformed to 4 ft x 6 ft dimensions, eliminating field forming and ensuring consistent loop geometry.
A: A paveover loop is placed directly on top of an existing pavement surface and then covered with a new layer of asphalt or concrete. This eliminates the need for a saw cut in the existing surface, making it ideal for new construction or planned resurfacing projects.
A: This loop is designed to connect to the Genie 112723 loop detector module or any compatible open/auxiliary input on Genie commercial gate operators that accepts a 2-wire inductive loop input.
A: No. A paveover loop must be installed before the final asphalt or concrete surface is poured or laid. It is not suitable for installation in existing finished pavement, which requires a sawcut loop instead.
A: Genie loop sealant part number 110341 is recommended as a cross-reference accessory for sealing and securing the loop leads and connections during or after installation.
A: The loop uses 18 AWG lead wires with a 2-wire output configuration designed to feed an inductive loop detector. The detector monitors changes in inductance caused by a vehicle passing over or stopping on the loop.
