The Genie 110823.0001.S is an OEM service replacement Push-On Retaining Ring for Genie commercial gate operators. This Push-On Shaft Retaining Ring is manufactured to Genie specifications and designed for direct fitment in authorized service procedures. Compatible with Genie commercial gate operators - various series, Used on shafts where groove-type retaining ring is not suitable operator models. Constructed from Metal (steel or hardened spring steel typical for push-on retaining rings). Press-on to shaft - no groove required.
A: A push-on retaining ring installs by pressing directly onto a shaft without requiring a machined groove. Internal teeth or prongs grip the shaft to hold the ring in place.
A: No groove is required. The ring grips the shaft by friction and mechanical engagement of its teeth or prongs when pressed on.
A: Push-on rings are typically considered one-time-use fasteners. Removal may damage the ring, so a new ring should be used if the component is disassembled.
A: Use a push-on retaining ring tool or flat punch to press the ring evenly onto the shaft until seated. Do not hammer unevenly as this can distort the ring.
A: This retaining ring is used in Genie commercial gate operator assemblies to retain components on shafts where grooved retaining rings are not practical.
