Genie GE-113315.0001.S 12V 7Ah SLA Gate Operator Battery
The Genie GE-113315.0001.S is a 12V 7Ah SLA replacement battery for select Genie gate operator battery backup systems. Genie documentation identifies 113315.0001.S as the 12V, 7Ah SLA replacement battery used where the operator battery box and wiring are designed for this battery type.
This is a battery replacement item, not a complete gate operator, power supply, charger, battery harness, battery case, solar panel, charge controller, control board, or complete battery backup kit. Match this part by exact part number, voltage, amp-hour rating, battery type, terminal style, physical size, polarity, and operator documentation before ordering.
Primary Use
- Replacement 12V 7Ah SLA battery for select Genie gate operator battery backup systems
- Used where the operator manual or parts diagram lists 113315.0001.S
- Supports battery backup operation where the operator is designed to run from two 12V batteries
- Service replacement when the original battery is weak, sulfated, swollen, leaking, not holding charge, or past normal service life
- Used in solar-capable or AC-powered Genie gate operator systems where the battery configuration matches the operator documentation
Compatible With
Use this battery only where the installed Genie operator documentation confirms 113315.0001.S or a 12V 7Ah SLA battery is the correct replacement. Do not assume every Genie gate operator uses the same battery size or package quantity.
- Select Genie GLA24V linear actuator swing gate operator applications where the manual lists 113315.0001.S
- Select Genie GRSW24V residential swing gate operator applications using 12V 7Ah battery backup wiring
- Select Genie GRSL24V residential slide gate operator applications where the parts diagram or manual confirms 12V 7Ah battery compatibility
- Repairs where the original battery is marked, listed, ordered, or cross-referenced as GE-113315.0001.S or 113315.0001.S
- Applications using the correct battery box, retaining bar, battery disconnect switch, fuse protection, and charging circuit for 12V 7Ah SLA batteries
Features and Specifications
| Specification | Details |
| Brand | Genie |
| Part Number | GE-113315.0001.S / 113315.0001.S |
| Service Description | Battery, 12V, 7Ah |
| Product Type | Sealed lead-acid replacement battery |
| Voltage | 12V |
| Capacity | 7Ah |
| Battery Type | SLA / sealed lead-acid, where specified by Genie documentation |
| Typical Operator Battery Setup | Many supported Genie gate operators use two 12V 7Ah batteries; confirm required quantity before ordering |
| Terminal Style | Verify terminal size and connector fit before ordering, especially if the original battery or harness was changed |
| Battery Backup Use | Supports operator battery backup where the battery system, charger, and wiring are working correctly |
| Solar Use | May be used in supported solar-capable Genie systems where the solar charging setup is correctly sized |
| Package Quantity | Confirm before ordering; supplier listings may sell one battery or a pair |
| Included Accessories | Do not assume harnesses, retaining bar, charger, fuses, case, or mounting hardware are included unless specifically listed |
Important Comparison With Similar Genie Battery Parts
Genie gate operator battery parts can be confused because several related power components may be used in the same control box. Confirm whether you need the battery itself, a battery pair, a larger battery option, a charger/power supply, or wiring parts before ordering.
- GE-113315.0001.S / 113315.0001.S: 12V 7Ah SLA replacement battery for select Genie gate operator applications.
- 113381.0001.S: Related Genie 12V 35Ah battery option commonly listed as a larger battery set. This is not the same as the 7Ah battery.
- 113443.0001.S: 24V 350W power supply. This is a power supply, not a battery.
- 113475.0001.S: Dual battery case. This is a battery enclosure/accessory and is not the same as the battery itself.
- 113478.0001.S: Solar wiring kit. This is wiring for solar-related installations and not the battery.
- 113456.0001.S: Solar panel kit. This is a charging source and not the battery.
- Generic 12V batteries: May not have the correct amp-hour rating, dimensions, terminal style, or performance for the operator. Verify before substituting.
Also Known As / Related Part Numbers
- GE-113315.0001.S
- 113315.0001.S
- GE1133150001S
- 1133150001S
- Genie GE-113315.0001.S
- Genie 113315.0001.S
- Genie 12V 7Ah battery
- Genie 12V 7AH SLA battery
- Battery, 12V, 7AH
- 12V 7Ah SLA gate operator battery
- Replacement battery for Genie gate operator
- Genie gate opener backup battery
- Genie gate operator battery backup battery
- 113381.0001.S - related 12V 35Ah battery set, not the same 7Ah battery
- 113443.0001.S - related 24V power supply, not the same part
- 113475.0001.S - related dual battery case, not the same part
- 113478.0001.S - related solar wiring kit, not the same part
- 113456.0001.S - related solar panel kit, not the same part
Technician Notes
- Replace batteries as a matched set where the operator uses two batteries. Mixing an old battery with a new battery can reduce backup performance and shorten battery life.
- Confirm polarity before connecting the battery harness. Reversed polarity can damage fuses, wiring, control boards, chargers, or power components.
- If the gate runs slowly, stops during travel, shows low-battery faults, or will not operate during a power outage, test both batteries under load before replacing other parts.
- A new battery will not fix a failed charger, blown battery fuse, bad battery disconnect switch, damaged harness, corroded terminal, weak solar charging source, or control board charging fault.
- Inspect the battery box for corrosion, swelling, leakage, loose terminals, rubbed wires, insect damage, water intrusion, and damaged retaining hardware.
- Allow the batteries to fully charge before testing backup operation. Backup cycle count depends on gate weight, gate condition, accessory load, temperature, battery age, and charge level.
- Do not replace the battery with a random power supply or non-approved battery type. The operator battery system is designed around the correct battery chemistry, capacity, wiring, and charging circuit.
- Dispose of sealed lead-acid batteries properly according to local battery recycling rules.
Before Ordering Checklist
- Confirm the exact part number is GE-113315.0001.S or 113315.0001.S.
- Confirm the installed Genie operator manual calls for a 12V 7Ah SLA replacement battery.
- Confirm how many batteries are required for the operator. Many supported Genie gate operators use two 12V 7Ah batteries.
- Confirm whether this listing is sold as one battery or a pair.
- Confirm the battery terminal style, connector fit, physical size, and battery box clearance.
- Confirm the battery disconnect switch, battery fuse, charger, power supply, harness, and terminals are in good condition.
- Confirm whether the installation uses AC charging, solar charging, or an optional larger battery configuration.
- Confirm you do not need the 12V 35Ah battery set, dual battery case, solar wiring kit, power supply, or battery harness instead.
- Confirm the original problem is not caused by a dragging gate, weak charger, blown fuse, high accessory current draw, bad safety device, or control board fault.
Professional Advisory
Gate operator battery replacement involves stored energy, polarity-sensitive wiring, fuses, charging circuits, solar equipment, and moving-gate controls. If the batteries are swollen, leaking, overheated, repeatedly failing, or connected to damaged wiring or a questionable charger, have the system checked by a qualified gate operator technician. Do not bypass battery fuses, safety devices, grounding, monitored photo eyes, safety edges, reset circuits, or operator protections. Disconnect power sources and battery power before service, and recycle old sealed lead-acid batteries properly.
Product Q&A
What is Genie GE-113315.0001.S used for?
Genie GE-113315.0001.S is a 12V 7Ah SLA replacement battery for select Genie gate operator battery backup systems where the operator documentation lists 113315.0001.S.
Does this listing include one battery or two batteries?
Package quantity must be confirmed before ordering. Genie documentation shows two 12V 7Ah batteries used in supported operators, but supplier listings may sell one battery or a pair.
Can I replace only one battery if my Genie operator uses two?
Replacing both batteries as a matched set is usually the better service practice. Mixing a new battery with an old weak battery can reduce backup performance and shorten battery life.
Is GE-113315.0001.S the same as the 35Ah Genie battery option?
No. GE-113315.0001.S is the 12V 7Ah battery. The 35Ah battery option is a different Genie battery configuration and should not be substituted unless the operator documentation supports it.
Will a new battery fix a gate that runs slowly?
It may help if the batteries are weak, but slow gate movement can also be caused by a dragging gate, weak charger, bad fuse, voltage drop, high accessory load, control board issue, or mechanical binding.
What should I check before replacing the battery?
Check battery age, voltage under load, polarity, terminal condition, battery fuse, battery disconnect switch, charger output, wiring harness, corrosion, water intrusion, and whether the gate moves freely by hand.
Can I use any 12V 7Ah battery in place of this Genie battery?
Do not assume any 12V 7Ah battery is correct. Confirm SLA chemistry, physical size, terminal style, connector fit, amp-hour rating, and operator documentation before substituting a generic battery.
