LiftMaster 08-2001 Rod End Fitting
The LiftMaster 08-2001 rod end fitting is a mechanical linkage part used in the arm assembly of select commercial swing gate operators. This style of fitting helps connect the operator arm or extension arm hardware while allowing the linkage to move through its normal travel without binding. On a swing gate operator, small linkage parts carry a lot of load each time the gate starts, stops, reverses, or reaches the open and close limits. A worn rod end can create loose arm movement, noise, uneven gate travel, or extra stress on the gearbox and mounting hardware. This replacement part should be matched by the original part number and the operator parts diagram because similar-looking rod ends can have different thread sizes, bore sizes, or mounting offsets.
Compatible With
Common Compatible Models and Applications
- select LiftMaster CSW200 swing gate operators
- select LiftMaster CSW24 swing gate operators
- LiftMaster SW470 and SW490 style arm assemblies when the parts diagram calls for 08-2001
- industrial swing gate operator arm linkage applications using the 08-2001 rod end fitting
Important Compatibility Notes
- Match the stamped or listed part number before ordering.
- Verify arm style, rod-end thread size, and mounting hardware from the operator parts diagram.
- Do not substitute a similar rod end if the bore, thread, or offset is different.
Features & Specifications
| Feature / Specification | Details |
|---|
| Manufacturer | LiftMaster / Chamberlain Group |
| Product Type | Rod end fitting / arm linkage fitting |
| Part Number | 08-2001 |
| Application | Swing gate operator arm linkage repair |
| Compatible Operator Type | Select commercial and industrial swing gate operators |
| Commonly Associated Models | CSW200, CSW24, and SW470/SW490 style arm assemblies when confirmed by parts diagram |
| Notes | Verify thread, bore, arm style, and hardware before ordering |
Also Known As / Related Part Numbers
- 08-2001
- LM-08-2001
- 08 2001
- Rod End Fitting
- Extension Arm Holder
- Heim Joint Style Rod End
Technician Note
This is a replacement part that should be matched to the original LiftMaster part number, operator model, and factory parts diagram. If the operator has damage from impact, gate drag, water intrusion, missing safety devices, or electrical failure, inspect the complete system instead of replacing one part by appearance only.
Before Ordering
- Confirm the exact manufacturer part number from the original part or manual.
- Verify the operator model, production generation, and parts diagram.
- Compare dimensions, mounting points, connector style, voltage, frequency, or hardware style when relevant.
- Check related worn parts so the new replacement is not damaged by the same issue.
- Use a qualified gate or garage door technician for high-voltage, spring/counterweight, motor, or unsafe movement concerns.
Professional Advisory
Gate and barrier operators are moving systems with pinch points, stored force, and electrical components. Do not bypass required safety devices or continue operating equipment that moves unpredictably. When the repair involves electrical diagnosis, counterweight balance, operator alignment, or a damaged gate structure, have the system inspected by a qualified technician.
Product Questions and Answers
What does the 08-2001 rod end fitting do?
It connects part of the swing gate operator arm linkage and allows the arm assembly to move through its travel without binding.
Can I use this on any LiftMaster swing gate operator?
No. It should only be used where the operator parts diagram or original part number calls for 08-2001.
What are common signs this rod end fitting may be worn?
Loose arm movement, rattling hardware, uneven gate motion, or visible wear at the linkage joint can point to a worn rod end or related arm hardware.
Is mounting hardware included?
Kit contents can vary by supplier, so match the product listing and reuse only safe hardware that is in good condition.
Can a similar rod end be substituted?
Substitution is not recommended unless the thread, bore, size, and strength rating match the original application.
