LiftMaster 10-2013 Mounting Bracket
The LiftMaster 10-2013 mounting bracket is a replacement structural bracket used on select LiftMaster commercial swing gate operators, including SW470GL and SW490GL applications. The mounting bracket helps hold operator hardware in the correct position so the gate arm and drive assembly can operate with the proper geometry. If this bracket is bent, cracked, missing, or installed out of alignment, the gate may pull unevenly, bind, or place excess load on the arm and gearbox. This is not a cosmetic part; it should be matched to the correct operator model and installed with attention to gate alignment, hinge condition, and mounting surface strength. For older operators, always compare the existing bracket to the parts diagram before ordering because SW-series configurations may vary by generation.
Compatible With
Common Compatible Models and Applications
- LiftMaster SW470GL swing gate operators
- LiftMaster SW490GL swing gate operators
- select SW470 / SW490 bracket applications where 10-2013 is listed
Important Compatibility Notes
- Confirm exact model and generation before ordering.
- Compare bracket shape, mounting holes, and installation position with the original part.
- Check for gate sag or operator base movement before replacing the bracket.
Features & Specifications
| Feature / Specification | Details |
|---|
| Manufacturer | LiftMaster / Chamberlain Group |
| Product Type | Mounting bracket |
| Part Number | 10-2013 |
| Application | Swing gate operator bracket replacement |
| Compatible Operator Type | Commercial swing gate operators |
| Commonly Associated Models | SW470GL and SW490GL |
| Notes | Verify bracket position, hole spacing, and operator generation |
Also Known As / Related Part Numbers
- 10-2013
- LM-10-2013
- 10 2013
- Mounting Bracket
Technician Note
This is a replacement part that should be matched to the original LiftMaster part number, operator model, and factory parts diagram. If the operator has damage from impact, gate drag, water intrusion, missing safety devices, or electrical failure, inspect the complete system instead of replacing one part by appearance only.
Before Ordering
- Confirm the exact manufacturer part number from the original part or manual.
- Verify the operator model, production generation, and parts diagram.
- Compare dimensions, mounting points, connector style, voltage, frequency, or hardware style when relevant.
- Check related worn parts so the new replacement is not damaged by the same issue.
- Use a qualified gate or garage door technician for high-voltage, spring/counterweight, motor, or unsafe movement concerns.
Professional Advisory
Gate and barrier operators are moving systems with pinch points, stored force, and electrical components. Do not bypass required safety devices or continue operating equipment that moves unpredictably. When the repair involves electrical diagnosis, counterweight balance, operator alignment, or a damaged gate structure, have the system inspected by a qualified technician.
Product Questions and Answers
Which models commonly use the 10-2013 mounting bracket?
It is commonly listed for LiftMaster SW470GL and SW490GL swing gate operator applications.
Is this the same as the 10-2011 gate bracket?
No. 10-2013 is a mounting bracket, while 10-2011 is a gate bracket used at a different point in the arm system.
What should I check before replacing this bracket?
Check the original bracket shape, mounting holes, operator model, hinge condition, and gate alignment.
Can a damaged mounting bracket cause operator noise?
Yes. A loose or bent bracket can allow the arm assembly to move out of alignment and create noise or binding.
Should this be installed by a technician?
A qualified gate technician is recommended when bracket damage involves gate movement, welding, structural mounting, or operator alignment.
