LiftMaster K41-0092-000 APS Encoder with Cable for HDSW24UL
The LiftMaster K41-0092-000 APS encoder is a position-sensing service kit used on the HDSW24UL heavy-duty swing gate operator. The encoder provides position feedback to the operator control system so the gate can track movement, slow down correctly, and respond to travel setup and safety logic. If the encoder, cable, or mounting is damaged, the operator may lose accurate position reference or produce travel-related faults. Since position feedback is part of the monitored control system, the encoder should be replaced only with the correct HDSW24UL service kit and the gate should be checked for mechanical binding before setup is repeated.
Features & Specifications
| Manufacturer | LiftMaster |
|---|
| Product Type | APS encoder replacement kit |
|---|
| Part Number | K41-0092-000 |
|---|
| Application | Gate position feedback service for HDSW24UL |
|---|
| Compatible Operator Type | Heavy-duty commercial swing gate operator |
|---|
| Primary Model Reference | HDSW24UL |
|---|
| Included Components | Encoder with cable in common listings |
|---|
Compatible With
This part is commonly associated with the following LiftMaster operator models or product families. Always verify by the original part number, operator model, suffix, and parts diagram before ordering.
- LiftMaster HDSW24UL heavy-duty swing gate operator
- HDSW24UL parts diagrams listing K41-0092-000
- HDSW24UL APS encoder and cable replacement applications
Also Known As / Related Part Numbers
- K41-0092-000
- 41-0092-000
- 410092000
- APS encoder HDSW24UL
- Absolute position sensor HDSW24UL
- Encoder with cable HDSW24UL
Technician Note
Encoder replacement may require setup or relearning after installation. If position faults continue, inspect the cable, connector, control board, and mechanical gate movement.
Before Ordering Checklist
- Confirm HDSW24UL model and part number.
- Inspect encoder cable, connector, and mounting before ordering.
- Check for mechanical binding or gate travel obstruction.
- Review diagnostic codes and setup procedure.
- Do not substitute RPM sensors or encoders from other operator families.
Professional Advisory
Heavy-duty gate operator repairs should be performed by a qualified gate technician when electrical power, battery wiring, high-load gate movement, or safety-device circuits are involved. Do not bypass monitored entrapment protection devices to make an operator run.
Product Questions & Answers
What does the K41-0092-000 APS encoder do?
It provides position feedback for the HDSW24UL swing gate operator.
What symptoms can point to an APS encoder issue?
Possible symptoms include position faults, incorrect travel behavior, setup problems, or damaged encoder wiring.
Does this encoder fit HDSL24UL?
The strongest references list K41-0092-000 for HDSW24UL swing gate applications.
Is this the same as an RPM sensor?
No. It should be treated as the HDSW24UL APS encoder service kit, not a generic RPM sensor.
Will the operator need setup after replacement?
It may need travel/position setup according to the service manual after encoder replacement.
