LiftMaster K41-0110-000 Camera Window and Gasket, CAPXL
The LiftMaster K41-0110-000 is a camera window and gasket replacement kit used on CAPXL and CAPXLV high-capacity connected access systems. The window sits in front of the camera area and the gasket helps seal the opening against weather. On outdoor community and commercial entry systems, this part helps maintain camera visibility while protecting the inside of the enclosure from dust, rain, insects, and humidity.
This kit is commonly ordered when the camera window becomes scratched, cracked, cloudy, loose, or no longer seals properly. It is not the camera electronics and it is not a power supply or board. Because CAPXL and CAPXLV assemblies can use specific exterior parts, confirm the correct kit number before ordering. Also inspect the enclosure for bent panels or gasket surface damage, since a new gasket may not seal correctly against a distorted housing.
Compatible With
- LiftMaster CAPXL High Capacity Connected Access System
- LiftMaster CAPXLV High Capacity Connected Access System when the parts diagram lists K41-0110-000
- CAPXL/CAPXLV camera window service applications
- Not a replacement for camera module CAPXLCAM, K002A1978 power supply, or K41-38476 unless the parts diagram confirms the same service location
Features & Specifications
| Manufacturer | LiftMaster / Chamberlain Group |
|---|
| Product Type | Camera window and gasket kit |
|---|
| Part Number | K41-0110-000 |
|---|
| Application | CAPXL/CAPXLV camera window sealing and service |
|---|
| Compatible System Type | High-capacity connected access systems |
|---|
| Included Components | Camera window and gasket components as supplied in current kit packaging |
|---|
| Notes | Verify against CAPXL or CAPXLV parts diagram |
|---|
Also Known As / Related Part Numbers
- K41-0110-000
- 41-0110-000
- K410110000
- Camera Window and Gasket CAPXL
- CAPXL/CAPXLV Camera Window and Gasket Replacement Kit
Technician Note
If a CAPXL or CAPXLV video image is hazy, inspect both the exterior window and the internal camera. Clean installation matters; fingerprints, debris, or a pinched gasket can reduce image quality or compromise the weather seal.
Before Ordering
- Confirm the original part number on the removed component or parts diagram matches K41-0110-000 or a listed related number.
- Check the exact access system model and generation before ordering.
- Inspect the enclosure for water intrusion, corrosion, broken tabs, or damaged cable connections before replacing parts.
- Do not substitute similar-looking electronic, camera, lock, or power parts unless the model documentation confirms the match.
- Disconnect power according to the manufacturer instructions before servicing the enclosure.
Professional Advisory
Access control equipment may involve low-voltage wiring, locks, network connections, or power supplies inside a live enclosure. If the system has water intrusion, damaged wiring, unsafe gate movement, or repeated electrical failures, have the installation inspected by a qualified gate or access control technician.
Product Q&A
Is K41-0110-000 the camera module?
No. It is the camera window and gasket kit, not the electronic camera assembly.
Which access systems use this kit?
It is associated with LiftMaster CAPXL and CAPXLV high-capacity connected access systems when listed in the parts diagram.
Why replace the camera window and gasket?
Replace it when the window is scratched, cracked, cloudy, loose, or when the gasket no longer seals the camera opening.
Is this the same as K41-38476?
Do not assume that. K41-38476 is another camera window and gasket part number commonly tied to CAPXL service, so match the exact diagram.
Can a damaged gasket cause system problems?
Yes. A failed gasket can allow moisture into the enclosure, which may damage camera, display, wiring, or board components over time.
