LiftMaster K99-WH-REF 1 Inch White Reflective Tape
The LiftMaster K99-WH-REF is a 1 inch white/silver reflective tape service item used to improve visibility on select LiftMaster traffic control and perimeter access systems. Reflective tape is a small part of the overall system, but it plays an important role in helping drivers identify traffic-control equipment in low light, poor weather, and high-glare environments.
This tape is commonly used around traffic spike systems, barrier arms, warning surfaces, lane equipment, and other LiftMaster traffic-control hardware where the original reflective marking has faded, peeled, or been damaged. It is not a moving part, safety sensor, controller, or operator component.
Use this item to restore visible marking on compatible LiftMaster traffic-control assemblies. Surface preparation matters: old adhesive, dirt, oil, and rough surfaces can reduce bond strength, so the installation surface should be cleaned and inspected before applying replacement tape.
Features & Specifications
| Manufacturer | LiftMaster |
|---|
| Product Type | Reflective tape |
|---|
| Part Number | K99-WH-REF |
|---|
| Application | Traffic control visibility and marking replacement |
|---|
| Compatible System Type | Select LiftMaster manual and automated traffic control systems |
|---|
| Tape Width | 1 inch |
|---|
| Color | White / silver reflective |
|---|
| Notes | Tape only; operator, arm, sign, and traffic spike hardware are not included |
|---|
Key Features
- Improves visibility of compatible traffic-control equipment
- Useful for faded, missing, or damaged reflective markings
- Commonly associated with LiftMaster manual and automated traffic-control systems
- Can support driver awareness around spike lanes, signs, covers, and barrier equipment
Compatible With
- Select LiftMaster automatic traffic control systems
- Select LiftMaster manual traffic control systems
- LiftMaster perimeter access systems requiring 1 inch white reflective tape
- Traffic spike, barrier, warning, and lane-control components where 1 inch white reflective tape is specified
- Verify the required tape color, width, and placement before applying
Also Known As / Related Part Numbers
- K99-WH-REF
- 99-WH-REF
- LM-K99-WH-REF
- 1 Inch White Reflective Tape
- White/Silver Reflective Tape
Common Replacement Reasons
- Original reflective tape is faded, peeling, cracked, or missing
- Traffic-control equipment is difficult to see at night or in rain
- Warning surfaces need refreshed visibility after service or repainting
Technician Note
Reflective tape improves visibility but does not replace warning signs, safety devices, traffic lane markings, or required system maintenance.
Before Ordering
- Confirm the system calls for 1 inch white/silver reflective tape
- Clean and dry the application surface before installing the tape
- Check whether red, yellow, or other reflective markings are also required elsewhere on the system
- Inspect the traffic-control device for physical damage before replacing tape only
Professional Advisory
Do not rely on reflective tape alone to make a hazardous lane safe. Damaged spike systems, barrier arms, signage, or safety devices should be repaired by a qualified technician.
Product Questions & Answers
What width is K99-WH-REF?
K99-WH-REF is listed as 1 inch white/silver reflective tape.
Is this tape a safety sensor?
No. It is reflective marking tape only and does not detect vehicles, pedestrians, or gate movement.
Where is this tape commonly used?
It is commonly used on select LiftMaster traffic-control and perimeter access equipment where white reflective marking is required.
Can it be applied over dirty or loose old tape?
No. The surface should be cleaned, dried, and prepared so the new tape can adhere properly.
Does this fit automated and manual systems?
It may be used on select LiftMaster automatic and manual traffic-control systems where 1 inch white reflective tape is specified.
