NICE / APOLLO A2088, KIT, LIMIT ASSEMBLY
The Nice Apollo A2088 limit assembly kit is used for actuator limit-system repair where a more complete assembly is needed. On Apollo linear actuators, the limit system is responsible for stopping the gate at the correct open and close points. If the limit mechanism is worn, loose, damaged, or missing pieces, the actuator may stop short, run too far, fail to recognize a limit, or put unnecessary stress on the gate and control board. A2088 should be handled as a model-specific actuator service kit, not a universal limit switch. It is closely related to other Apollo limit parts, including A2074 limit block and switch assembly, A2038 limit tower assembly, A2002 magnetic block, A2004 proximity switch, and A2052 bushing. Select the kit by the actual actuator diagram and condition of the existing limit components.
Compatible With
- Compatible Nice Apollo actuator limit assemblies where A2088 is specified
- Commonly researched with Apollo 816 actuator limit service
- May apply to select 416 / 816 style actuator limit systems when parts diagram confirms the kit
- Apollo 1500 / 1550 / 1600 / 1650 systems using compatible Apollo linear actuators
- Not a universal substitute for every limit switch or magnetic limit part
Features & Specifications
| Manufacturer | Nice Apollo |
|---|
| Product Type | Limit assembly kit |
|---|
| Part Number | A2088 |
|---|
| Related Number | 20208890 |
|---|
| Application | Limit assembly repair for compatible Apollo actuators |
|---|
| Compatible Operator Type | Swing gate actuator limit systems |
|---|
| Notes | Verify actuator generation and existing limit assembly style |
|---|
Also Known As / Related Part Numbers
- A2088
- NICE-A2088
- Apollo A2088
- Nice Apollo A2088
- 20208890
- Limit assembly kit
- Limit kit
- Actuator limit kit
- Related parts: A2074, A2038, A2002, A2004, A2052
Technician Note
For Apollo actuator parts, do not order by appearance only. Small differences in actuator generation, cable length, SMART feedback, limit style, connector layout, or internal hardware can make similar parts non-interchangeable. Compare the original part number, actuator model label, and exploded parts diagram before replacing the component.
Before Ordering Checklist
- Confirm the actuator model and operator series on the installed gate system.
- Match the original part number or the manufacturer parts diagram whenever possible.
- Check whether the repair involves a standard 816 actuator, 816X SMART actuator, 416 actuator, or another Apollo arm.
- Inspect related wear parts before replacing only one component.
- For electrical parts, disconnect power and have unsafe wiring or high-current diagnosis handled by a qualified gate technician.
Professional Advisory
Gate actuators are moving mechanical assemblies tied to control-board logic and required safety devices. After replacing internal actuator, harness, motor, sensor, or limit parts, the gate should be tested through full open and close cycles with proper force settings, limit settings, entrapment protection, and safety accessories in place. Do not bypass safety devices to make a repaired gate run.
Product Questions & Answers
What does the A2088 kit repair?
A2088 is used for actuator limit assembly repair where the open and close stopping mechanism needs a broader service kit.
Is A2088 the same as A2074?
No. A2074 is a limit block and switch assembly. A2088 is a limit assembly kit and may be the better choice when multiple limit components are involved.
What symptoms can indicate limit assembly problems?
Common symptoms include early stopping, over-travel, failure to recognize open or close limits, or repeated limit adjustment problems.
Can this be used on any Apollo gate opener?
No. Use A2088 only on compatible Apollo actuator assemblies where the parts diagram confirms the kit.
What should be done after replacing limit parts?
Open and close limits must be reset and tested, and all required safety devices should remain installed and operating.
