GTO SW4200XLS Replacement Arm with 40' Cable for SW4000XLS Operators - Secondary Arm Only
The PROSW4200ARMXLS is the secondary actuator arm for the Linear / GTO PRO-SW4200XLS dual swing gate operator family. It is used with the heavy-duty SW4000XLS/SW4200XLS system where the second leaf requires a longer cable run back to the control box. The secondary arm must match the operator series, cable length, connector layout, and installed gate geometry.
This product needs careful review because supplier wording can vary on cable length. Your uploaded product name says 40 ft cable, while several common PRO4200ARMXLS references describe a 50 ft cable. That difference matters on a dual swing gate because a cable that is too short cannot be routed correctly, and a mismatched actuator can create sequencing and limit issues. The page content below uses cautious wording and asks the buyer to confirm the original arm label and cable requirement before ordering.
Find Replacement Parts for SW4200XLS
Compatible With
Primary Fitment
- Linear / GTO PRO-SW4200XLS secondary swing gate operator applications
- Dual swing gate systems paired with PRO-SW4000XLS master operator when confirmed by parts diagram
Related But Not Directly Interchangeable
Features & Specifications
| Manufacturer | Linear / GTO |
|---|
| Product Type | Replacement secondary swing gate actuator arm |
|---|
| Part Number | PROSW4200ARMXLS |
|---|
| Application | Secondary arm for SW4200XLS dual swing systems |
|---|
| Cable Length | Uploaded row says 40 ft; common listings often show 50 ft - verify inventory label |
|---|
| Compatible Operator Type | Heavy-duty residential swing gate operator |
|---|
| Notes | Model and cable length must be confirmed before ordering |
|---|
Also Known As / Related Part Numbers
Technician Note
This is a model-specific secondary arm. Check the original arm label and actual cable length before shipping because a 40 ft versus 50 ft cable mismatch can stop an otherwise correct repair.
Before Ordering
- Confirm the failed actuator is on a PRO-SW4200XLS secondary leaf.
- Verify whether your stocked arm has a 40 ft or 50 ft cable.
- Do not substitute the PROSW4000ARMXLS primary arm for the secondary side.
- Inspect brackets, gate stops, cable routing, and control board output before replacing the actuator.
- Confirm the dual gate sequencing and safe operation after installation.
Important Ordering Warnings
- Cable length conflict: uploaded name says 40 ft, while common PRO4200ARMXLS references often show 50 ft. Confirm the stocked part label before upload or shipment.
Professional Advisory
This arm is used on larger dual swing gate systems. For heavy gates, damaged hinges, or unsafe movement, the repair should be completed by a qualified gate technician.
Product Q&A
Is PROSW4200ARMXLS the secondary arm?
Yes. It is commonly associated with the PRO-SW4200XLS secondary arm used in dual SW4000XLS/SW4200XLS swing gate systems.
Is the cable 40 ft or 50 ft?
The uploaded row says 40 ft, but multiple common listings describe PRO4200ARMXLS with 50 ft cable. The current inventory label should be confirmed before upload or shipment.
No. PROSW4000ARMXLS is the primary/master arm reference and PROSW4200ARMXLS is the secondary arm reference.
Will it work on a SW3200XLS dual system?
No direct fitment should be assumed. SW3200XLS uses a different secondary arm family.
What should be checked if the secondary gate does not move?
Check board output, wiring, cable damage, battery voltage, gate binding, and actuator condition before replacing the arm.
