Linear 2200-930 is a v-belt manufactured by Linear/OSCO for use in their gate operator product line. 4L x 27 in Cogged V-Belt for Linear Gate Operators. Constructed from Rubber with fiber cord reinforcement. 27 in nominal outside circumference, 4L cross section. Belt drive - routed over matched V-belt pulleys.
A: The 4L270 standard belt is interchangeable with the Linear 2200-930 in most cases, as the dimensions and cross section are identical.
A: The 4L cross section has a top width of approximately 1/2 in and a depth of approximately 5/16 in, and is commonly used in fractional horsepower drive applications.
A: The outside length is 27 in, making it 3 in longer than the 2200-929 belt, which may correspond to a different pulley center distance or operator configuration.
A: Cogged belts flex more easily around pulley grooves, generate less heat, and often last longer than equivalent non-cogged belts in the same application.
A: V-belts should be installed with correct tension - enough to prevent slipping under load but not so tight as to overload motor or shaft bearings.
